Purification Ozone Stick (Replacement)

Replacement Purification Plate "Ozone stick"
 
What it does:
Produces Activated Oxygen (O3) when using the purification settings and/or "Away" mode in the BLS12K, MCI22K, MCI PureSynAIRg and GreenTech GT1500/ pureAir1500 air purification units.
 
Activated Oxygen (O3 ) Output - Purification Plate (Optional Usage). . . . . . . . . . . . . . 0 - 360 mg/hr
 
Effective Area. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250 - 2,200 ft2
 
How to Tell if It's Working:
Purification level is controlled on the REMOTE and adjusts the output of Activated Oxygen (O3) produced by the purification plate. Four levels are available and will be signified by varying colors on the CONTROL PANEL.
 
LEVEL 0 (0 - 250ft2): LED is OFF.
 
LEVEL 1 (250 - 500ft2): LED is GREEN
 
LEVEL 2 (500 - 1000ft2): LED is YELLOW
 
LEVEL 3 (1000 - 1500ft2): LED is RED
 
CAUTION: Never adjust the setting to exceed the square footage of the ventilated space being treated.
 
When the air purifier is on, the purification plate can be detected by smell if it is not on Level 0. Level 0 uses only DBI, PCO and Ionizaition Technology.  The purification plate should have a dim purple glow when looking through the front grille of the unit (best viewed in a dark room).
 
Away Mode
Away Mode is used to treat the toughest odors in your space with higher levels of Activated Oxygen and Ionization.
 
To activate, press the AWAY MODE BUTTON on the CONTROL PANEL or REMOTE.  Away Mode is active for 2 Hours before reverting back to previous settings. 
 
CAUTION: DO NOT use Away Mode in an occupied space. Prolonged exposure to Activated Oxygen may result in temporary respiratory or eye irritation.
 
When to Clean:
The ozone stick only needs cleaning every 3 months, and replaced every 2-3 years of constant use under normal conditions, more often if used in a harsh environment (smoking area, kitchen, pet area, etc.). 
 
Using a 50/50 mix of warm water and clear ammonia, soak the purification plate for 1-8 hours. Using a soft-bristle brush, scrub the metal center. Rinse thoroughly and allow to dry completely before reinstalling.